How to install the three-way ball valve

1, remove the three-way ball valve flange on both sides of the protective cover, the valve is fully open in the state of cleaning and cleaning.

2, the installation should be in accordance with the provisions of the signal (electricity or gas) for the whole machine test (to prevent the vibration caused by the use of transport performance), qualified before the on-line installation (wiring by electric actuator circuit diagram

3, ready to be connected with the pipeline before the need to rinse and remove the remaining impurities in the clean pipe (these substances may damage the seat and the ball).

4, during installation, please do not use the valve part of the actuator as lifting point to avoid damage to the implementing agencies and accessories.

5, this type of valve should be installed in the horizontal or vertical direction of the pipeline.

6, the installation point near the pipeline can not be low or bear the phenomenon of external force, you can use the pipe support or support to eliminate the deviation of the pipeline.

7, and pipe connection, please use the specified torque cross-locking flange bolts.

The company's main three-way ball valve, thin ball valve, high platform ball valve, welcomed the purchase.